guides and related products

We are proud to offer guides and spacers for circular saws, all of superior quality.

Our steel guides are made of a high strength alloy and heat treated in order to obtain maximum surface hardness and protection against rust. The lubrication holes are therefore not obstructed by rust. In addition, this treatment gives a smooth black finish.

Our aluminum guides are anodized, thus increasing their surface hardness up to 50 HRc. All our aluminum guides have solid steel insert in tapped holes.

The lubrication holes are pipe threaded (NPT), thus not needing Teflon.

The straightness of our guide is within 0,0005 po.†

La parallelism between each side of our guide is within 0,0005 po.†

The guide arm thickness is warranted not to exceed the target and not more than 0,0005 po. under it.†

†: Apply only to new guides and spacers.

Guide check-up jig

Manufactured specially for your guide shape.
Available with heat treated shaft and puller, to prevent wear.
Anchoring holes 9/16po., allows fixing the jig to the work bench.

Drilled screw

Available in different length.
Huge quantity in stock.
Standard hole 1/16". Other sizes available on special order.
Sold by lot of 100 or more.
Standard allen socket flat head 1/4-UNC. Other thread available on special order.

Babbitt mould

Pneumatic or manual mould.
Mould with 1 or 2 cylinder depending on the geometry of the Babbitt plates.
Possibility of manufacturing 1 only mould for 2 type of Babbitt plate, since it takes less space in your shop.

Also available:

Process panel for guided saw lubrication, manifold block to mix air ,oil and water.
Babbitt ASTM B23 #2 without lead.
Saw guide lubricant.
Crucible, use to melt Babbitt metal.
Spoon to pour melted Babbitt metal in mould.
Bull retrofit: adding guide to standard machine, improve guide design, guide tightening system, etc.
Guide and spacer grinding, should you wish to change the target measure or the thickness of the blade.